Leveling Operations
1.Reverse Gear Preference
For grading tasks, prioritize reverse gear movement. When forward grading is necessary, maintain bucket rollback angle ≤20° for optimal material control.
2.Three-Step Grading Method
Material Collection: Engage bucket at low RPM, then increase throttle gradually to prevent wheel spin
Spreading: Keep teeth grounded, utilizing rear traction force for even distribution
Fine Grading: Activate hydraulic float mode for precision surface finishing
Loading & Hauling Protocols
1.Transport Configuration
Lower bucket to maintain 15-30cm ground clearance during transit for stability
2.Efficiency Cycle
Standard workflow includes:
Material excavation
Short-distance transport
Targeted unloading
3.Route Management
Maintain designated haul roads to reduce tire wear
Maximum efficiency within 100m range; recommended speed limits:
Paved surfaces: ≤25km/h
Rough terrain: ≤15km/h
Safety Alerts
Never lift loads while moving to prevent rollover accidents
On soft ground, reduce tire pressure or use graded approach techniques